$244.76

Our advanced 1 Part Urethane Reinforced Alkyd is surprisingly economical considering the outstanding performance and quality this unique floor coating supplies. A durable waterproof floor enamel finish that is so tough, so durable you will want to use it in a wide variety of applications. Provides long lasting service on all interior and exterior surfaces or anywhere protection from exposure to challenging weather conditions require the toughest alkyd and urethane floor finishes. As with TS-100 1 Part Epoxy it utilizes blended resin technology making it a remarkably durable floor finish. A fully waterproof floor paint so it’s an excellent choice for kitchens and public bathrooms. Create a beautiful, high gloss, chemical resistant, protective coating when you use TS-4 as a garage floor coating. Can be used almost anywhere and in almost any floor coating application where you want a hard, tough, long-lasting protective coating inside or out. Use it with confidence in any exterior application where exposure to water, hot sun, and extreme wear conditions are typically a problem. Great for interior or exterior uses where protection from heavy foot traffic, abrasion, or typical wear and tear are a concern. It dries quickly and self levels to a hard gloss finish that is excellent for wood, concrete, metal, fiberglass, aluminum and most any surface conceivable. Spray, brush or roll it on! It is self-leveling, lead-free, non-toxic and resists chipping, cracking peeling and chalking when properly applied. Acceptable for use as a epoxy paint, garage floor coating, cement coating, professional garage floor coating, industrial floor coating, basement floor paint, hardwood floor finish, cement paint or as an alternative to typical concrete coatings or epoxy floor coatings. When used as a concrete coating or basement floor paint for the home or in lieu of an epoxy floor coating it provides good performance and durability for up to 10 years. For added slip resistance in high traffic areas add 1 lb Gaco-Grip or Tred-Tex slip resistant paint additives on a per gallon basis. These non slip paint additives are available on our supplies page. (See TS-222 Floor Grip non skid coating or TS-110 non skid paint for slip resistant paint, deck paint and concrete coating applications)  Not available in clear.

Stats: Covers 400-500 square feet per gallon on porous surfaces such as concrete, up to 500 square feet on non porous surfaces. Dry to the touch in 2-4 hours. Pot life: Not applicable * Very high in solid content so it will require reduction in most applications. Compatible for electrostatic spray. Low temperature curing (as low as 20 F.) Available in 200 stock floor paint colors. Custom colors available on request for an additional $5.00 per gallon. Available in quart, gallon and five gallon containers

Recommended preparation: For best results remove old paint, loose scale, grease, oil and contaminates. Sand, grind, bead blast or power-wash prior to the application of any cleaner or primer. Steel: TS 5679 Phos-Pro Rust Converting Cleaner, TS 695 Etching Cleaner. When painting cement, wood or coating concrete, surfaces must be thoroughly dry before the application of and cement paint application.

Recommended primers: Concrete & masonry-TS 6390 Ever-Last Epoxy Primer or TS 664 Etching Primer. Wood-TS 664 Etching Primer. Fiberglass, aluminum and composite materials-TS 117 Pre-Wash Primer in combination with TS 664 Etching Primer. Steel & iron: TS 117 Pre-Wash Primer in combination with TS 664 Etching Primer or TS 900 Fabrication Primer.

Thin & clean up: Use only with factory recommended thinner, TS 101 Thinner. Clean all equipment thoroughly with TS 101 Thinner or TS 602 Mineral Spirits.

Accelerate/Harden: See TS-160 Accelerator/Hardener on SUPPLIES Page. Reduce gloss: See TS-150 Gloss Reducer on SUPPLIES Page.