Only Top Secret makes this kind of modern floor coatings technology available to the public! This fully waterproof floor coating is versatile, good looking and exceptionally durable! Guaranteed for up to 20 years when properly applied according to application recommendations. Specifically formulated to out perform all epoxy, urethane, alkyd and resin blends in high abuse applications. A government spec performance equivalent that meets specification number MIL-PRF-85285 so you know you are getting the best! It’s exactly what governmental agencies buy for their floor coating applications, concrete structures, facilities and infrastructure. A two-component linear aliphatic urethane designed for exceptional durability and resistance to strong chemicals, high heat, spilled fuel, acids, alkalis, solvents, saltwater and corrosion over a variety of substrates. Acceptable for use as a garage floor coating, industrial floor coating, basement floor paint, hardwood floor finish or as an alternative to typical concrete coatings or epoxy floor coatings. Yellowing and chalking can be a big problem for typical epoxy floor finishes, not so with TS2 Hard-Shell Urethane. This extraordinary floor coating is recommended for all interior and exterior applications where abusive conditions typically require yearly reapplications of commercial floor coatings. With proper surface preparation and application will provide the user with years of lasting beauty and protection. Acceptable for use on almost any surface. When used as cement paint, concrete coating, garage floor paint or basement floor paint for the home or in lieu of an epoxy floor coating it provides exceptional performance and durability for up to 20 years! Recommended when painting cement, tile, masonry, ferrous metals, prepared steel, aluminum, fiberglass and wood. Resists many chemicals, fuels and staining agents. (See TS-222 Floor Grip non skid coating or TS-110 non skid paint for slip resistant paint, deck paint and concrete coating applications) Not recommended for use with TS 100 1 Part Epoxy paint, TS 100 Epoxy Clear and TS-4 Urethane Reinforced Alkyd.

Stats: Covers 400-500 square feet per gallon depending on surface and specific application requirements. Dry to the touch in 30 minutes-1 hour. Mixing Ratio: 7:1 (by volume) with Part B (Induction Time: 15 minutes) Pot life: 4 hours * It is supplied at spray viscosity suitable for most conventional systems. Compatible for electrostatic spray. Low temperature curing (as low as 20 F.) Available in 200 stock floor paint colors. Custom floor colors available on request for an additional $5.00 per gallon. Available in half-gallon and one gallon kits.

Recommended preparation: For best results remove old floor paint, loose scale, grease, oil and contaminates. Sand, grind, bead blast or power-wash prior to the application of any cleaner or primer. Steel: TS 5679 Phos-Pro Rust Converting Cleaner, TS 695 Etching Cleaner. When painting cement, wood or coating concrete, surfaces must be thoroughly dry before the application of and cement paint application.

Recommended primers: Concrete & masonry-TS 6390 Ever-Last Epoxy Primer or TS 664 Etching Primer. Wood-TS 664 Etching Primer. Fiberglass, aluminum and composite materials-TS 117 Pre-Wash Primer in combination with TS 664 Etching Primer. Steel & iron: TS 117 Pre-Wash Primer in combination with TS 664 Etching Primer or TS 900 Fabrication Primer.

Thin & clean up: Use only with factory recommended thinner, TS 620 Thinner Reducer. Clean all equipment thoroughly with TS 620 Thinner Reducer or TS 610 Lacquer Thinner.