|
A
versatile, easy to use hi-performance rust preventative primer for
use with ferrous and non ferrous metal and galvanized surfaces.
Fabrication Primer is an etching primer that creates a chemical bond
to whatever it is applied to. A premium-grade, high solid primer
that acts as an rust inhibiting protective coating locking out air
and moisture to prevent rust. Resistant to moisture, salt spray and
chemicals. TS-900 Fabrication Primer that not only acts as a rust
preventative on steel and iron substrates but should be viewed as an
integral component of any corrosion resistant roof coating system.
It penetrates cracks around light rust and mill scale. Additionally,
it protects corners and edges and resists exposure to the damaging
effects of weather. Intended for use as a roof paint primer coat for
properly prepared surfaces. Use on interior or exterior structural
steel and under most any paint. Excellent for shop equipment, tanks,
metal structures of all kinds, doors and handrails. Color: White or
Grey. Finish is low sheen. Available in quart, gallon or five gallon
cans.
Stats:
Dries to the touch in 30 minutes, tack free in 1 hour, recoatable in
2 hours, dries hard in 4 hours. Apply by brush, roller or spray.
Coverage is approximately 250 square feet per gallon, depending on
the texture and porosity of the surface. Dries to the touch in 30
minutes. Recoat in 8 hours. Apply by brush, roller or spray.
Recommended preparation: For best results remove old metal roof
paint, loose scale, grease, oil and contaminates. Sand, grind, bead
blast or power-wash prior to the application of any cleaner or
primer. Steel: TS-5679 Phos-Pro Rust
Converting Cleaner, etch concrete with
TS-695 Etching Cleaner. All surfaces must be thoroughly dry
before the application of any metal roof paint.
Application: Primer should be allowed to dry a minimum of two to
three hours before recoating with subsequent primers or roof coating
systems. It should be applied to a dry film thickness between
0.3-0.5 mil. NOTE: This primer is designed for application over
surface-treated metal or pretreatment coatings (See
TS-117 Pre-Treatment Wash Primer).
If used for dip or flow-coat application, the product suitability
should be determined by the user.
Thin & clean up: TS-605 Thinner.
Clean spills and tools immediately with TS-605 Thinner.
NOTE:
Use with elastomeric roof paints, epoxy roof paint, fiberglass roof
paint, flat roof paints, flat roof coating, acrylic roof paint,
aluminum roof coatings, concrete roof paint, elastomeric roof
coating, flat roof coatings, metal roof paint, roof sealant, RV roof
coating, rubber
roof coating, paint
for rusty metal, tile roof paints, steel roof coatings, tin roof
paint, zinc roof paint, metal roof paints and tile roof coatings
|
