|
Ever-Last Epoxy Roof Paint is a two component, high
performance catalyst-cured epoxy roof paint. It provides unequaled
hardness and chemical resistance in harsh and abusive environments
and where atmospheric acids quickly corrode lesser roof coatings. It
provides unequaled adhesion, hardness, chemical resistance and is
fully submersible making it a favorite in industrial and commercial
applications. Use it wherever salt air and abusive weather
conditions requires a hard, highly durable rust preventative
protective epoxy roof paint. Provides outstanding service in
virtually all interior or exterior applications. Intended for use on
metal, wood, fiberglass, aluminum, asphalt and composite materials.
Excellent for chemical splash zones and the interior and exterior of
water tanks and piping. When used as an aluminum roof paint or
fiberglass roof paint it provides exceptional performance and
durability. Ever-Last Epoxy Roof Paint can be self priming depending
on type of substrate and application, however, a primer coat is
typically necessary. Apply using brush, roller or spray
(conventional, airless or electrostatic).
Stats: Covers 275-300 square feet per gallon on porous surface, up
to 400 square feet on non porous surfaces. Dry to the touch in one
hour, tack free in 8 hours, recoat in 24 hours. Pot life is 8 hours
@ 70 degrees F. Available in 200 marine paint schemes. Custom
colors are available on request. Available in low sheen, semi-gloss
and gloss. Available in 1 gallon, two gallon and 5 gallon kits.
Recommended preparation: For best results remove old coatings, loose
scale, grease, oil and contaminates. Sand, grind, blast or
power-wash prior to the application of any cleaner or primer. Steel: TS-5679 Phos-Pro
Rust Converting Cleaner, etch fiberglass and aluminum with
TS-695 Etching Cleaner. All surfaces must be thoroughly dry
before the application of any marine paints or primer.
Recommended primers: Wood-TS-664 Etching
Primer. Fiberglass and aluminum materials-TS-117
Pre-Wash Primer in combination with TS-664 Etching Primer.
Steel-TS-6390 Ever-Last Epoxy Primer.
Best performance will be obtained when used over lacquer resisting
primers including TS-664 Etching Primer and TS-6390 Ever-Last Epoxy
Marine Primer. Recommend TS-1184 Zinc
Chromate Primer for anti-corrosion protection.
Thin & clean up: Thinning not typically required. Use only with
factory recommended thinner, TS-605 Thinner.
Clean all equipment thoroughly with TS-605
Thinner. Clean up with TS-605 Thinner or
TS-610 Lacquer Thinner.
|
