|
Our
best selling and most popular primer because of its versatility,
sandability and protective qualities over a wide variety of
substrates. It creates a virtually unbreakable chemical bond to
whatever it has been applied to which allows it to be used almost
anywhere and most any application! This is the primer of choice in
wood, fiberglass and aluminum roof paint applications. Meets
government specification number TT-P-664D. A hi-performance
Phenolic Modified Alkyd Etching Primer specially formulated for use
with hard to prime surfaces such as aluminum and fiberglass. Also
acceptable for use with metal or iron surfaces. TS-664 Etching
Primer is lacquer proof, fast drying, high solid primer that
inhibits rust, is resistant to salt spray and penetrates cracks
around light rust and mill scale. It protects corners and edges and
resists exposure to the damaging effects of weather. Intended for
use as a primer coat for properly prepared surfaces. Use on any
interior or exterior surfaces. A premium-grade, high solid primer
that not only acts as an effective rust preventative on steel and
iron substrates but should be viewed as an integral component of any
corrosion resistant coating system. Lacquer proof primer and finish
coats such as nitrocellulose lacquers may be applied directly over
it without the worry of lifting or wrinkling. Available in quart,
gallon or five gallon cans. Color: White or Red Oxide. Finish is low
sheen.
Stats:
Dries to the touch in 30 minutes, tack free in 1 hour, recoatable in
2 hours, dries hard in 4 hours. Apply by brush, roller or spray.
Coverage is approximately 250 square feet per gallon, depending on
the texture and porosity of the surface. Dries to the touch in 30
minutes. Recoat in 8 hours. Apply by brush, roller or spray.
Recommended preparation: For best results remove old metal roof
paint, loose scale, grease, oil and contaminates. Sand, grind, bead
blast or power-wash prior to the application of any cleaner or
primer. Steel: TS-5679 Phos-Pro Rust
Converting Cleaner, etch concrete with
TS-695 Etching Cleaner. All surfaces must be thoroughly dry
before the application of any metal roof paint.
Application: Roof primers should be allowed to dry a minimum of two
to three hours before recoating with subsequent roof coating
products. It should be applied to a dry film thickness between
0.3-0.5 mil. NOTE: This primer is designed for application over
surface-treated metal or pretreatment coatings (See
TS-117 Pre-Treatment Wash Primer).
If used for dip or flow-coat application, the product suitability
should be determined by the user.
Thin & clean up: TS-605 Thinner.
Clean spills and tools immediately with TS-605 Thinner.
NOTE:
Use with elastomeric roof paints, epoxy roof paint, fiberglass roof
paint, flat roof paints, flat roof coating, acrylic roof paint,
aluminum roof coatings, concrete roof paint, elastomeric roof
coating, flat roof coatings, metal roof paint, roof sealant, RV roof
coating,
rubber
roof coating, paint
for rusty metal, tile roof paints, steel roof coatings, tin roof
paint, zinc roof paint, metal roof paints and tile roof coatings
|
