|
A
versatile, easy to use hi-performance rust preventative fabrication
primer for use with ferrous and non ferrous metal and galvanized
surfaces. TS Fabrication Primer is a premium-grade, high solid, low
VOC coating that acts as a rust inhibiting primer locking out air
and moisture to prevent rust. Resistant to moisture, salt spray and
chemicals. TS-900 Fabrication Primer is a premium-grade, high solid,
low VOC sandable primer that not only acts as a rust preventative on
steel and iron substrates but should be viewed as an integral
component of any corrosion resistant coating system. It penetrates
cracks around light rust and mill scale. Additionally, it protects
corners and edges and resists exposure to the damaging effects of
weather. Intended for use as a rust stopping primer for properly
prepared surfaces. Use on interior or exterior structural steel and
under most any paint. Excellent for shop equipment, tanks, metal
structures of all kinds, doors and handrails. Color: White or Grey.
Finish is low sheen. Available in quart, gallon or five gallon cans.
Stats: Dries to
the touch in 30 minutes, tack free in 1 hour, recoatable in 2 hours,
dries hard in 4 hours. Apply by brush, roller or spray. Coverage is
approximately 300 square feet per gallon, depending on the texture
and porosity of the surface. Dries to the touch in 30 minutes.
Recoat in 8 hours. Apply by brush, roller or spray.
Recommended
preparation: For best results remove old marine coating, loose
scale, grease, oil and contaminates. Sand, grind, bead blast or
power-wash prior to the application of any cleaner. All surfaces
must be thoroughly dry before the application of any boat primers,
topside coatings, bottom paints, spar varnish or brightwork varnish.
Application:
Marine primers should be allowed to dry a minimum of two to three
hours before recoating with subsequent boat primers or marine
coatings. It should be applied to a dry film thickness between
0.3-0.5 mil. For non-marine equipment or on iron or steel surfaces
it should be applied to 0.6-0.8 mil dry film. NOTE: This marine
primer is designed for application over surface-treated metal or
pretreatment coatings (See TS 117 Pre-Treatment Wash Primer). If
used for dip or flow-coat application, the product suitability
should be determined by the user.
Thin & clean up:
TS 605 Thinner. Clean spills and tools immediately with TS 605
Thinner. |
