|
There is no replacement for the protective qualities
of zinc and TS-1757 Zinc-Plate Primer definitely has it. A
rust-inhibiting Red Oxide zinc primer that is easy to spray and
fast-setting. It is based on a zinc chromate-ferric oxide
anti-corrosion industrial coating system. This invaluable zinc
primer binds rust to metal sealing out rust causing air and
moisture. It is intended for use as a protective metal primer for
new or rusted surfaces. Designed primarily as a corrosion-inhibiting
primer for use on manufactured goods, equipment, machinery, ferrous
and nonferrous metal surfaces before top coating with urethane,
lacquer or enamel industrial paints A premium-grade, high solid rust
stopping primer that not only acts as an effective rust preventative
on steel and iron substrates but should be viewed as an integral
component of any protective coating system. It is zinc rich and
contains a balanced composition of special pigments and phenolic
modified resin providing good rust-inhibitive properties and blister
resistance for better adhesion and metal protection. Color: Red
Oxide. Product type: Zinc Chromate Rust-Inhibitive Primer. Available
in one gallon or five gallon cans.
Application: This product is at a
spray viscosity designed for airless use: The primer should be
allowed to dry a minimum of 2 hours before recoating with subsequent
primers or topcoats. It should be applied to a dry film thickness
between 0.3-0.4 mil. For non-aircraft, airborne equipment, or on
iron or steel surfaces it should be applied to 0.6-0.8 mil dry film.
It is satisfactory for application in a wide range of temperatures
or humidity conditions.
NOTE: This primer is designed for
spray application over surface-treated metal or pretreatment
coatings. If used for dip or flow-coat application, the product
suitability should be determined by the user. Color: Red Oxide.
Product type: Zinc Chromate Rust-Inhibitive Primer. Physical
characteristics: Viscosity: 20-25 sec. #2 Zahn. Dry to the touch:
5-10 minutes, tack free: 20 minutes, time to recoat: 30 minutes, dry
hard: 30 minutes. Weight Solids: 58-60%. Practical coverage is
300-350 square feet per gallon @ approximately 2.0 mils dry. Stir
thoroughly before use. Brush, roller, or spray. It should not be
thinned unless absolutely necessary. Thin if necessary with TS 605
Thinner. Tools and equipment may be cleaned with TS 605 Synthetic
Thinner or TS 610 Lacquer Thinner. Available in quart, gallon or
five gallon cans.
|
