|
Aqueous is an innovative water-based epoxy-acrylic
blend that provides many of the favorable characteristics of
solvent-based epoxies but without the oil base. A VOC compliant,
easy to use, water-based, one-part epoxy coating that out performs
typical water-based enamels; which is why it ranks a ten! An
excellent choice for industrial paint applications manufactured
goods and facility maintenance. Offer s a high level of corrosion
and impact resistance not typically supplied by typical latex
paints. Withstands inclement weather, salt air, heavy foot traffic,
constant wet and dry conditions and the destructive effect of ultra
violet rays. Aqueous Epoxy is an easy to use, water-based,
environmentally friendly formula that really performs.
Acceptable for use in interior and exterior applications. A durable
industrial paint system intended for use in high traffic, hard use
areas where exceptional weathering properties and excellent color
retention are desired. Fast drying and acceptable for use in cold
weather conditions. Acceptable for use on pressure treated wood. For
added slip resistance in high traffic areas add 1 lb
Gaco-Grip or
Tred-Tex paint additives on a per
gallon basis. These non slip paint additives are available on our
supplies page.
Stats: Two coats are recommended for best results. Practical
coverage is up to 300 square feet on sealed surfaces! Approximately
250-300 square feet per gallon on wood, masonry, concrete or
unsealed surfaces depending on texture and porosity. Dry to the
touch in 1 hour. Pot life: Not applicable. Available in quart,
gallon or five gallon cans. Not recommend for constant immersion
service, strong acid or chemical exposure. Apply by brush, roller or
spray. Available in satin and semi-gloss. Available in 200
industrial paint colors.
Recommended preparation: For best results remove old
coatings, paint, loose scale, grease, oil and contaminates. Sand,
grind, bead blast or power-wash prior to the application of any
cleaner or primer. Steel: TS-5679 Phos-Pro
Rust Converting Cleaner, etch concrete with
TS-695 Etching Cleaner. All surfaces must be thoroughly dry
before the application of any industrial primer or industrial
paints.
Recommended primers: Works best when used in combination with
TS 100-10 Peel Stopping Primer, TS-204
Sandable Primer, TS-664 Etching Primer or TS-900 Fabrication Primer.
Thin
& clean up: Thins and washes up easily with water.
Acceptable for use as: A protective coating, pipe coating, metal
coating, rust preventative paint or protective coating on a wide
variety of substrates. Not recommended for: Use in areas subject to
tire traffic. Not for continual immersion service. Use as an
alternative to other rust preventative coating. Compatible
industrial clear coatings include TS-100 1 Part Epoxy Clear Coating.
|
