|
Our advanced Urethane Reinforced Alkyd is
surprisingly economical considering the outstanding
performance and quality this unique coating delivers. A
durable enamel that produces a durable glossy finish in a
wide variety of applications. Provides excellent protective
qualities on equipment, tools, machines, interior and
exterior trim or anywhere protection from exposure to
challenging weather conditions requires a tough alkyd
industrial paint. Like 1-Part Epoxy it utilizes blended
resin technology making it an excellent choice for use on
exterior surfaces such as tanks, pipes, roofing materials,
bridges, control panels and superstructure. Use it with
confidence in any exterior application where exposure to
water, hot sun, and extreme wear conditions are typically a
problem. Great for interior or exterior uses where
protection from heavy traffic, abrasion, or typical wear and
tear are a concern. It dries quickly and self levels to a
hard gloss finish that is excellent for wood, metal,
fiberglass, aluminum and most any surface conceivable. When
used as a protective coating for aluminum, steel or
fiberglass substrates it provides exceptional performance
and durability. Spray, brush or roll it on! It is
self-leveling, lead-free, non-toxic and resists chipping,
cracking peeling and chalking when properly applied.
Economical to use because it spreads further than typical
industrial coatings. Not available in clear.
Stats:
Covers 400-500 square feet per gallon on porous surfaces
such as concrete, up to 500 square feet on non porous
surfaces. Dry to the touch in 2-4 hours. Pot life: Not
applicable * Very high in solid content so it will require
reduction in most applications. Compatible for electrostatic
spray. Low temperature curing (as low as 20 F.) Available in
200 stock marine paint colors. Custom colors available on
request for an additional $5.00 per gallon. Available in
quart, gallon and five gallon containers
Recommended preparation: For best results remove old paint,
loose scale, grease, oil and contaminates. Sand, grind, bead
blast or power-wash prior to the application of any cleaner
or primer. Steel: TS 5679 Phos-Pro Rust Converting Cleaner,
TS 695 Etching Cleaner.
Recommended primers: Concrete & masonry-TS 6390 Ever-Last
Epoxy Primer or TS 664 Etching Primer. Wood-TS 664 Etching
Primer. Fiberglass, aluminum and composite materials-TS 117
Pre-Wash Primer in combination with TS 664 Etching Primer.
Steel & iron: TS 117 Pre-Wash Primer in combination with TS
664 Etching Primer or TS 900 Fabrication Primer.
Thin &
clean up: Use only with factory recommended thinner, TS 101
Thinner. Clean all equipment thoroughly with TS 101 Thinner
or TS 602 Mineral Spirits.
Accelerate/Harden: See TS-160 Accelerator/Hardener on
SUPPLIES Page.
Reduce
gloss: See TS-150 Gloss Reducer on SUPPLIES Page.
NOTE:
Not an antifouling bottom paint. Recommend TS 700 Old Sailor
Bottom Paint for antifouling paint duty.
|
