|
Fabrication Primer
(TS-900) is an etching primer that produces a tenacious weather proof bond
that locks out moisture and water vapors preserving protective top
coatings including Deck-Pro and 1-Part Epoxy years longer. Widely used
and well liked for its waterproofing properties, etching bond and
excellent flexibility over a wide variety of substrates including wood,
concrete, tile even linoleum. Like TS-664 Etching Primer it is lacquer
proof, fast drying, and has a very high solid content. However, it
produces a thinner film build making it less costly to use than TS-664
Etching Primer. It’s a hi-performance Phenolic Modified Alkyd Primer
specially formulated for use with hard to prime surfaces such as wood,
vinyl and Linoleum.
Fabrication Primer works especially well on wooden decks with Deck-Pro
allowing Deck-Pro and 1 Part Epoxy to be successfully applied to almost
any surface. Use on any interior or exterior surfaces.
Excellent for use on virtually any wood, concrete, steel, fiberglass
surfaces in marine environments. It resistant to saltwater, penetrates
cracks and protects corners and edges from the damaging effects of
weather. Virtually any coating may be applied directly over it without the
worry of lifting or wrinkling. Available in gallon or five gallon cans.
·
Produces an etching bond to whatever it is applied to.
·
Covers
in just one coat.
·
Works
exceptionally well on wood.
·
Provides superior adhesion and durability.
·
Easy
application; just brush, roll or spray it on.
·
Economical and easy to use.
·
Withstands temperatures from -40F to 350F
·
Allows
low temperature applications down to 40F.
Stats:
This product is intended to serve as a primer coating for decks and
floors. IMPORTANT: A protective coating must be applied over it as a wear
layer. Coverage is 250-300 square feet per gallon, depending on the
texture and porosity of the surface. Dries to the touch in 30 minutes.
Recoatable in 1-2 hours. Apply by brush, roller or spray. Allows for low
temperature curing (as low as 40 F.) Color: White or gray.
Finish is low sheen.
Recommended
preparation:
Refer to Application Instructions Sheet included with order, label
directions and standard industry application practices. For best results
remove existing epoxy floor coatings, old floor paint, loose scale, wax,
oil and contaminates. For best results sand, blast, grind or power-wash
prior to the application of any primer or coating. Concrete, masonry,
tile, fiberglass or aluminum-strongly recommend the use of
TS-695 Etching Cleaner. All wood
surfaces must be thoroughly cleaned and dry before the application of
primer or coatings. All surfaces must be thoroughly
dry and free of contaminates before the application of any floor coating
system.
Thin & clean
up: Use
only with factory recommended thinner,
TS-605 Thinner. Clean all equipment
thoroughly with TS-605 Thinner. Clean up with TS-605 Thinner.
|
