Our advanced 1-Part Urethane Reinforced Alkyd provides a waterproof automotive enamel finish that is so tough, so durable you will want to use it in a wide variety of applications. Provides excellent service on all marine equipment, machines, interior and exterior trim or anywhere protection from exposure to challenging weather conditions requires the toughest alkyd and urethane finishes. Like TS-1 Revolution Marine it utilizes blended resin technology making it a remarkable product to use.  Create a beautiful, high gloss, chemical resistant, durable hard shell marine finish. TS-4 can be used almost anywhere and in almost any automotive paint application where you want a hard, tough, long-lasting protective coating inside or out. Use it with confidence in any exterior application where exposure to water, hot sun, and extreme wear conditions are typically a problem. It dries quickly and self levels to a hard gloss finish that is excellent for wood, metal, fiberglass, aluminum and most any surface conceivable.  It is self-leveling, lead-free, non-toxic and resists chipping, cracking peeling and chalking when properly applied. Economical to use because it spread further than typical automotive finishes. Not available in clear.

Stats: Covers 400-500 square feet per gallon on porous surfaces such as concrete, up to 500 square feet on non-porous surfaces. Dry to the touch in 2-4 hours. Pot life: Not applicable * Very high in solid content so it will require reduction in most applications. Compatible for electrostatic spray. Low temperature curing (as low as 20 F.) Available in 200 stock marine paint colors. Custom colors available on request for an additional $5.00 per gallon. Available in quart, gallon and five gallon containers

Recommended preparation: For best results remove old paint, loose scale, grease, oil and contaminates. Sand, grind, bead blast or power-wash prior to the application of any cleaner or primer. Steel: TS 5679 Phos-Pro Rust Converting Cleaner, TS 695 Etching Cleaner.

Recommended primers: Fiberglass, aluminum and composite materials-TS 117 Pre-Wash Primer in combination with TS 664 Etching Primer. Steel & iron: TS 117 Pre-Wash Primer in combination with TS 664 Etching Primer or TS 900 Fabrication Primer.

Thin & clean up: Use only with factory recommended thinner, TS 101 Thinner. Clean all equipment thoroughly with TS 101 Thinner or TS 602 Mineral Spirits.

Accelerate/Harden: See TS-160 Accelerator/Hardener on SUPPLIES Page.

Reduce gloss: See TS-150 Gloss Reducer on SUPPLIES Page.