|
The revolution continues with 1 Part Epoxy-Clear! 1 Part Epoxy Clear
utilizes the exclusive hybrid resin blend technology that Top Secret
Coatings is best known for. 1 Part Epoxy Aircraft Clear Coating
won’t crack, peel, chalk or yellow like typical epoxy or lacquer.
What makes it unlike typical clear aircraft coatings is that it
produces a film that remains both hard and flexible at the
same time. Its silicone epoxy base allows high flexibility, heat
resistance and UV stability while providing the excellent hardness,
scuff resistance and resistance to salt and chemicals you expect
from Top Secret. The single component oxygen cure allows it to hold
its gloss longer, makes it easier to work with and less hazardous.
No other product we are aware of has a wider range of application
possibilities. 1 Part Epoxy Clear Aircraft Coating adheres to almost
anything and self levels like a dream. Brush it on and watch the
brush marks disappear before your very eyes! It offers excellent
resistance to chemicals, spilled fuel, hydraulic fluid and acids. It
is impact resistant to 500 PSI and is heat resistant to 350+
degrees. It is gloss retentive, non-chalking and resists cracking,
chipping and peeling. Additionally, it covers up to three times the
area of typical performance coating because its maximum dry film
thickness is only two mils. 1 Part Epoxy Clear aircraft coating
provides outstanding adhesion to Steel, Wood, Composites, Ceramics,
even Aluminum! Excellent for use where spray restrictions are in
place because it is a self leveling formula that may be brushed,
rolled or sprayed.
Stats: Covers 400-450 square feet per gallon on porous surfaces such
as wood, up to 800 square feet on non porous surfaces. Dry to the
touch in 2-4 hours. Pot life: Not applicable * Very high in solid
content so it will require reduction in most applications.
Compatible for electrostatic spray. Low temperature curing (as low
as 20 F.) Available in low sheen, semi-gloss and gloss.
Recommended preparation: For best results remove old aircraft
coatings, loose scale, grease, oil and contaminates. Sand, grind,
blast or power-wash prior to the application of any cleaner or
aircraft primer. Steel: TS-5679 Phos-Pro
Rust Converting Cleaner, etch fiberglass and aluminum with
TS-695 Etching Cleaner. All surfaces must be thoroughly dry
before the application of any aircraft paint schemes.
Thin & clean up: Use only with factory recommended thinner,
TS-101 Thinner. Clean all equipment
thoroughly with TS-101 Thinner or TS-602
Mineral Spirits.
Accelerate/Harden: See TS-160
Accelerator/Hardener on SUPPLIES
Page.
NOTE: Acceptable uses: aerospace coating, aircraft coating,
aircraft clear coating, high performance aircraft coating. Use with
aircraft paint schemes, aircraft paint and coatings,
aircraft paint colors, high
performance aircraft coatings,
airplane paints and primers, aircraft paint and coatings, aircraft
paint schemes,
aircraft clear coating and high performance aircraft coatings.
Application Instructions
|
